In the department of fun and imagination and dreaming – with a base of vision – is this exercise of reworking the freight train schedule of Vermont Rail System as if all freight traffic that could went over the rails. All of this is based on traffic that is already moving, just waiting to be hauled by a train. It would be quite profitable. The catch is that it would take sizeable capital expenditures to realize this plan, and while the return on that investment would be better than that realized for road expenditures, it would not satisfy the capital markets.

The major through trains are the following:
Selkirk NY – Burlington – St. Albans (with mixed freight, autos and intermodal)
Mechanicville NY – Syracuse NY (CSX intermodal connector)
Selkirk NY – Brattleboro – St. Johnsbury – Orleans-Newport
St. Johnsbury-Groveton connection
New Haven CT – Orleans – Newport (connecting with MMA)
Selkirk NY – Florence (mostly Omya traffic for Selkirk)
Florence – Glens Falls NY (mostly Omya traffic for NY paper mills & CP)
Bellows Falls – Ticondaroga NY


In addition to switchers and locals there are bulk hauler shuttles that run all day long (maximizing car utilization) as mini unit trains (as short as just a few cars, but usually more like 10 cars). These haul aggregate, logs, wood chips and garbage. Cars used will be quick unloading bottom dump gondolas strengthened to haul logs so trains can be loaded in both directions and cars shuffled around from job to job. Because car utilization is so high and the trains are moving most of the time, these shuttles can make money (when operated with a crew of one person) even if the haul and train length is short.

You will note I’ve taken the liberty (as long as we are dreaming a bit) to expand the VRS system in a few directions that make sense. These could be services operated in cooperation with connecting railroads or outright takeovers.

The plan below assumes that main lines are operated at 40 mph (that’s the bulk of the capital expenditures) with new sidings as needed to facilitate operations and switches that are used every day equipped with time-saving radio controlled power switches.

Because of the power switches, improvements in track configurations and changes in switching procedures, time spent switching in this schedule is considerably reduced. Some of this could be because I’m not quite as familiar with operating requirements as I might be. Through freights will be blocked to drop set-offs off the rear with no switching, just a simple uncoupling and break test. Yard personnel with have a new FRED (flashing rear end device) ready to stick on the new last car.

Lowering time spent switching brings considerable improvements in productivity for all of the other cars in the through train that don’t need to wait as well. Faster timings will allow intermodal service to be operated competitively on the Selkirk-Burlington route.   more »